A Balboa spa heater stops working due to so many reasons. It may be due to issues with the Balboa heater tubes or the spa controller. Read the post and know when you need to replace your Balboa spa heater.
1. Check the water flow.
Your Balboa spa heater works efficiently on adequate water flow. A pressure switch connects to the heater chamber that detects the water flow. If the flow of water is too low, the heater stops working.
If this is an issue with your spa heating system, repairing the spa heater parts is unnecessary. The problem can be due to a dirty spa filter. You must remove the spa cartridge, clean the filter and check the pressure or flow rate. Other causes can be clogged spa jets or pipes, a broken pump impeller, or a broken valve. They can often reduce the water flow into your spa or hot tub, causing the spa heater to stop working.
2. Check the thermostat.
The thermostat is the dial you turn to increase the heat. Currently, most hot tubs have a solid-state thermostat connected to the circuit board. If you use a knob rather than a red arrow, you need to check your thermostat to know whether the unit is faulty or a corroded sensor bulb.
3. Check the high-limit switch.
The high limit switch is another switch like the thermostat and pressure switch. It helps in preventing the spa heater that won’t turn off. The system has maximum heat wherein the switch opens and shorts the electric circuit that brings power to the spa heater element. Use an amp meter or OHM meter to test your spa components.
4. Check the Balboa heater tubes.
Heater tubes are the essential elements of every spa heater. However, they can buildup scale from the hard water or salt systems used. If scale builds on the heater tubes, it will minimize heat and make the tubes stop working.
Eventually, your Balboa hot tub heater will fail to work. Likewise any heating element, most heater tubes have a life span of around five to ten years. Maintaining proper water chemistry is essential to prolong the lifetime of Balboa heater tubes.
If you have a Balboa heater and the heating element stops working, you will not need to replace the entire system. Instead, you need to replace the Balboa heater tubes. The Balboa heater tubes come with two flow sensors, stainless steel houses, and new 2” heater unions.
Replacing the Balboa heater tubes is very simple, and you can do it independently. So, you should buy replacement Balboa heater tubes from Northern Lights Cedar Tubs Direct. You will receive complete support, including detailed instructions on installing your Balboa hot tub heater tube.
Bottom Line –
Now you know the signs to replace your Balboa spa heater. If you need further information on replacing the spa heating systems, please contact Northern Lights Cedar Tubs Direct at 1-800-759-8990.
No comments:
Post a Comment